Archive
Type T thermocouple
今日收到了新訂的4條Type T sensor。今次連 Plug 買,貴多$30 ( HKD 80.44一條 )。
但個Plug用料比預期好,原來連接腳也是同樣物料以確保温度準確。
Wikipeida Thermocouple
Type T (copper–constantan) thermocouples are suited for measurements in the −200 to 350 °C range. Often used as a differential measurement since only copper wire touches the probes. Since both conductors are non-magnetic, there is no Curie point and thus no abrupt change in characteristics. Type T thermocouples have a sensitivity of about 43 µV/°C.
Koolance Quick Disconnect
星期六收到德國寄訂返來的水冷毒品, 其中包括了Koolance 的Quick Disconnects Fitting.
點知唔試玩, 試水發現漏水。後來換了另一個, 比之前漏得更快。
原來連接時個角度有差會整壞個O-Ring.
今朝走去旺角買O-Ring, 買左20隻 18×10x2mm (Koolance official 是17×11x1.75mm) 作替代.
HKIX 問題 2010-05-11 02:36
無端端上唔到網, 以為是屋企隻Firewall 個DNS Proxy 問題。點知一CHECK就知,原來是HKIX Peering的問的。
在2:36分左右VPN斷開了. 公司到IDC (HKBN-HKIX-IDC) 直線VPN failback 到經其中一個HGC Site 到IDC (HKBN-HGC-IPVPN-IDC) .
CHECK多一會確認是HKIX Peering問題後,只好deactivate Router 個HKIX BGP Peering。
Peering 到朝早回復正常
下圖是我將HKIX個RRD Graph 10/05 00:00-11/05 06:00 部份Overlap到09/05 00:00 的圖。發現2:00到6:00少了平均10Gbps 的traffic
Related Link
Openfiler RAID擴展、加碟
以下是測試Openfiler Software RAID 5 擴展的過程
環景是Vmware ESXi, 由6隻Virtual Disk的RAID5擴展到7碟
先是檢視現有的RAID,
/sbin/mdadm –detail /dev/md0
在VM加多一隻SCSI DISK後, 做一次SCSI Rescan 令到新碟顯示
把新碟初始化
parted /dev/sdh
mklabel msdos
mkpart primary ext2 0 8192
set 1 raid on
quit
並把新碟加入RAID
mdadm –add /dev/md0 /dev/sdh1
把RAID由6碟擴展為7碟
mdadm –grow /dev/md0 –raid-devices=7
在背景碟擴佔用CPU不多
完成RAID
到Physical Volume
再擴大Logical Volume
最後到XFS







































